Wheel Hex Please help make my yugioh deck better (dragon)?
My deck consists of -
Felgrand Dragon
Hamon Lord of Stricking Thunder
The Creator
Herald of Creation
The Creator Incarnate
Decoy Dragon
Darkblaze Dragon
Tyrant Dragon
3xBlue Eyes White Dragon
Morphing Jar
Goblin Attack Force
Great Maju Garzett
2xLuster Dragon
x-Head Cannon
Spear Cretin
Kaiser Sea Horse
Dark Blade
The Light-Hex Sealed Fusion
Snipe Hunter
Blue Eyes Ultimate dragon
-Magic/Traps
Horn of The Unicorn
Change of Heart
Spell Absorption
Stray Lambs
2xDraining Shield
Rope of Life
Lightning Vortex
Call of the Haunted
Next to be Lost
The Shallow grave
2xPolymerization
Mage Power
Two-Man Cell Battle
Banner of Courage
Ground Collapse
Trade In
2xMonster Reborn
Pot of Greed
Swords of Revealing Light
2xFoolish Burial
Sakuretsu Armor
Magic Cylinder
Nightmare Wheel
I know its kinda sketchy , but thats why I want some help .
Thanks in advance =)
There are some cards that go good in every dragon deck! Try to get them in, and your deck will improve 10-fold!
-Lord of D: this is to be used as a fusion material for King Dragun. With him, all your dragons are unaffected by effects! And in addition, one per turn you can special summon a dragon from your hand!
-Instead of Polymerizations put in a Future Fusion and some Dragon's Mirrors. This will get fusions out quicker and easier! Also just because of the Dragon's Mirrors you could try putting in a Five-Headed Dragon Fusion, because all you have to do is have 5 dragons in your graveyard and then activate Dragon's Mirror!
-Dragon's Rage: This would be really good for your deck, since all your dragons have high attack. It's a continuous trap that gives all your dragons trample!
Oh! And not sure if you knew, but Change of Heart, Monster Reborn and Pot of Greed are all banned! Sorry! If you want Similar cards try: Brain Control, Premature Burial and Pot of Avarice(which most people think is better).
Anyway, keep working on it and you'll have yourself a pretty decent deck!
I have replaced my roller-blade wheels and for some reasons, there is a lot more friction now than before.
Maybe I damaged the bearings? Is there a tool to remove the bearings (I used the hex key)? Is there a tool to put the bearing back in place (I used a hammer)?
Thanks in advance.
This is the tool I use for pulling bearings
www.rollerbob.com/partpics/med.RB_tool.jpg
www.rollerbob.com/cat-18.html
No tool is needed for putting them back in and never use a hammer. You could damage bearings with it.
Did you manage to forget to put in the bearing spacers?
It sounds silly because that would leave parts left over but I have seen it happen to people experianced with doing skate maintenance. It will make the wheels REALLY sluggish.
In order to get the bearings pushed ALL the way into the wheel, I use the rest of the wheels.
Pick up a stack of four wheels and crunch the stack together so that they push all the bearings on the inside of the stack get pushed in. Move to two bottom wheels to the top so that the bearings that were on the outside are in the middle and repeat. It is amazing how much more leverage you can get on the wheels this way instead of just trying to push in one at a time.
(I am assuming that all your bearings roll well out of the wheels)
If the bearings are a little slow after that, the bearings might still be slightly crooked in the wheels.
With the wheels in the skate, use your thumbs and fingers to push the visible part of the wheel to both sides. Rotate the wheel and repeat a couple times.
